SimplyCool
08-29-2008, 08:51 PM
|
|||
|
|||
How to connect ninja cooller to 5v ?
hellow
I wanna make voltage 5v for my Ninja mini cooller, and have fixed 1000 rpm. I dont like pwm function, because its not quite. How can i do this ? I just have no expirience :) 
|
|
08-30-2008, 06:47 AM
|
||||
|
||||
|
Use a voltage regulator like FanMate 2 or simply use a resistor like this one:
Zalman RC56 (7V) Noiseless Resistor Cable Zalman RC100 (5V) Noiseless Resistor Cable There are 2 versions, 56 Ohm (7V) and 100 Ohm (5V). You can also buy adapters that deliver 5V or 7V from a standard molex connector from your PC's PSU but you lose the ability of sending the speed sginal (rpm) to your mainboard if you connect the fan directly to the PSU. Bye Oli
__________________
- All comments relating to mainboard / cooler / case compatibility are based on "best guess". -
- Aussagen zur Kühler-Kompatibilität basieren auf unverbindlicher, persönlicher Einschätzung. - Push Postings will be deleted without notice.
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
