Yasya Clips Type ? And a question about a second fan

Liam · #1 (**permalink**) 07-28-2010, 10:30 AM

Hi,

Which type of clips fit the Yasya A or B ?

Can I use these clips ?

Scythe "120mm Fan Clip" for Scythe CPU Coolers with 120mm Fan

I want to buy a second Slip Stream PWM (1900rpm) fan for it, is it possible to make them both run simultaneity on PWM ?

If not how can I Control and keep them quiet (say below 1500rpm) ?

Thanks

Oli · #2 (**permalink**) 07-28-2010, 10:39 AM

Both fit. It doesn't depend on the cooler it depends purely on the fan itself - the pictures on the product page of the newer clips illustrate that.

That clips you refer to are the old ones which are called Type A today.

You can mount a 25mm fan with A and B. For fans thicker than 25mm you must take B. Fans with tunnels are only supported up to 25mm thickness (then you need type A).

There are PWM y cables available. I use one from Xilence to run my two Slipstream PWM fans on Mugen 1.

If you drop the PWM support the fans can also be regulated by voltage via 3-pin. There are at least 2 millions possibilities of regulating them. 3-pin y cable and regulation by mainboard connector if supported, Fanmate, fan controller from Scythe etc.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

#1 (permalink) 07-28-2010, 10:30 AM
Liam Junior Member Join Date: Jul 2010 Posts: 1	Yasya Clips Type ? And a question about a second fan Hi, Which type of clips fit the Yasya A or B ? Can I use these clips ? Scythe "120mm Fan Clip" for Scythe CPU Coolers with 120mm Fan I want to buy a second Slip Stream PWM (1900rpm) fan for it, is it possible to make them both run simultaneity on PWM ? If not how can I Control and keep them quiet (say below 1500rpm) ? Thanks

#2 (permalink) 07-28-2010, 10:39 AM
Oli Senior Member Join Date: Aug 2007 Location: Germany, in the middle of Europe Posts: 855	Both fit. It doesn't depend on the cooler it depends purely on the fan itself - the pictures on the product page of the newer clips illustrate that. That clips you refer to are the old ones which are called Type A today. You can mount a 25mm fan with A and B. For fans thicker than 25mm you must take B. Fans with tunnels are only supported up to 25mm thickness (then you need type A). There are PWM y cables available. I use one from Xilence to run my two Slipstream PWM fans on Mugen 1. If you drop the PWM support the fans can also be regulated by voltage via 3-pin. There are at least 2 millions possibilities of regulating them. 3-pin y cable and regulation by mainboard connector if supported, Fanmate, fan controller from Scythe etc. __________________ - All comments relating to mainboard / cooler / case compatibility are based on "best guess". - - Aussagen zur K�hler-Kompatibilit�t basieren auf unverbindlicher, pers�nlicher Einsch�tzung. - C2D E6700@3.33Ghz@1,28V / Mugen 1, Ret Kit & 2x Slip Stream PWM @ 280rpm