Missing parts - Scythe Orochi Rev. B

[thegraduate]

Originally Posted by Okiwana Okimoto

Hello,
I will send you the missing parts. Back from holidays and a lot of tickets anyway I have your address
Best Regards,
OKi

Thanks for your support. Any chance of getting an update on when these parts might arrive as it's holding up building the entire system (which is extremely annoying over such a relatively small problem)? Right now it looks like by the time this thing's finished it's going to be an antique.
It's my fault the screws got stripped, just a shame you don't include a few spares with the original product like some other manufacturers (eg. Zalman).
Anyway, if you've sent them already I appreciate it, but they havn't arrived yet. Last time they got here in just a few days, so I wonder if they're lost in the post. Could you let me know when you sent them? Thanks.

[Okiwana Okimoto]

Hello,

make please a support request and than I think we can help you .
Check: Request: Scythe EU GmbH

[thegraduate]

Thanks for advice - done.

[thegraduate]

Thank you to whoever was resposible. Nobody emailed me so I'll post it here. Cheers.

[Okiwana Okimoto]

Hi,

ticket-nr ? I have reply your request, but I need to check. Can you send me a PM with the number ?

Best Regards,
OKi

[thegraduate]

i came to unfasten the lga1366 backplate and in the process seem to have stripped the four lga1366 socket screw heads. no. 11 on the product manual [washer no. 8]
I have measured the screws and they came to length; 10mm, head [diameter] 4mm, shaft diameter 2mm. Is this another specialised part or can I possibly get it from a hardware store with the right info. could you tell me if it's a phillip's head or pozidriv I can't tell the difference and my chances of getting it locally at a DIY store as well as size classification [M2/M/M4] otherwise I'll have to put in another support request.

Thank you for your help,
good night

[Okiwana Okimoto]

Hello,

I will send you the missing parts. Back from holidays and a lot of tickets anyway I have your address

Best Regards,
OKi

[thegraduate]

Originally Posted by Okiwana Okimoto

Hello,

I will send you the missing parts. Back from holidays and a lot of tickets anyway I have your address

Best Regards,
OKi

Thanks for your support. Any chance of getting an update on when these parts might arrive as it's holding up building the entire system (which is extremely annoying over such a relatively small problem). Right now it looks like by the time this thing's finished it's going to be an antique.

It's my fault the screws got stripped, just a shame you don't include a few spares with the original product like some other manufacturers (eg. Zalman).

Anyway, if you've sent them already thank you, but they havn't arrived yet. Last time they got here in just a few days, so I wonder if it's they're lost in the post. Could you let me know when you sent them? Thanks.

[Okiwana Okimoto]

Hey,

parts are on way. It take some time mean it was to UK or ?

[thegraduate]

Thanks a bunch. Finally got the bits and pieces I needed.

Ran into a little problem later though - is there any way to mount the 14" fan without using the clip (part 13 - provided). For instance, what size screws do the holes in the fan take? That would get me started on bolting the thing down.

I appologise but I am simply terrible at misplacing parts.

Anyway, I appreciate your help so far, and I won't 'take the piss' as we say in England by requesting a third part. If you could suggest to me how I could connect the fan with nuts and bolts, and what size said nut would be (M4, M5?)

Thanks for your hard work
-thegraduate