Musashi Compatibility List

[kater]

Originally Posted by sumo

Hi Krzok559,
thats the problem, there is not enough space between the core und the dvi ports. At the end the Musashi is not compatable with the HD4770.

And what about putting the ends of the heatpies through the expansion slot (at the back of the case) - would it solve the problem?
I'm also considering the Musashi to be my cooler on HD4770.

[sumo]

Hi,

you have to bend the cooler for few mm to fit is this position!

[Bellum]

Hi!

I have some further questions about the Musashi on a SLI-system with two XfX Gts250. I have been informed that the cooler don´t take more space than the original ones, but how about the bolts on the backside?
With original coolers my GPU´s have just a few milimeters between them, and I am a bit worried that the bolts on the lower card might interfere with the fans on the upper one.

Does anyone have any experience with the Musashi on a SLI rig w two XFX 250GTS on an Asus PN5-D motherboard?

[Okiwana Okimoto]

Hmm, you can try this. We can´t give you the guarantee that this combination works. But normally it should be work with two gts 250 cards.

[Bellum]

I might give it a try then.. And if it doesn´t work: How well will the Musashi work without the fans? (I was considering removing the fans on the upper card if it interferes with the bolts on the lower one.. Or will that be a waste of time?

And what if I remove the fans from the upper card and place it on the side of the two cards (blowing on both in a 90 degree angle) ?

[milbe]

Originally Posted by sumo

the cooler give extra 2-3 cm over the PCB

How about height? I have HD 5850 and Lian Li V351.

[jwebby]

I have confirmed that the Musashi will fit an nVidia GT-240, specifically an Asus ENGT240/DI/512MD5/A.

[iaqb]

hello, anyone tried this with 9800gx2 ???

[Oli]

No DUAL-GPU card support.

[SocialUser]

Der Musashi Kühler ist inkompatibel mit der MSI HD3850. Wie man auf dem 1. Bild sieht, ist das grüne Bauteil mit Kupfer ummantelt (weiß nicht, was das ist ) höher als alles andere auf dem Board.
Das hat dann leider Bild 2 zur Folge. Wie man sieht, kann der Kühlkörper bei weitem nicht aufliegen.
Muß ich wohl leider dem Händler zurückgeben