tightening screws on Mugen 2 rev B

[goos]

Hi,

I read that on a Mugen 2 the screws that go through the motherboard have finite thread. So once they are tight the cooler aligns perfectly to the processor.

On a Mugen 2 rev B this is not possible. The position of the cooler with respect to the processor depends on the tightness of the four screws.

Is there maybe a trick-of-the-trade to align the cooler perfectly to the processor (needed to transport the heat efficiently)?

How are you sure that the cooler is mounted in the proper way ?

Goos

[bobsley12]

I would very much like to know the answer too. I've just got a new Mugen 2 B and I dont get very good temp. Around 70 on load. I will reinstal it again when I receive my Artic Silver 5.

thanks