Getting Mugen 2 tight to processor.

[texasboy]

A little bit of help if you might need it. The 4 screws supplied by scythe to attach the Mugen 2 to the back plate are only partially threaded. In my case with the Intel DX58SO board there was not quite enough thread to pull cooler tight enough to processor and temperatures were high. A simple packet of fully threaded 50 pcs of screw set screws/washers/nuts.for fan fix.
m3x20mm screws. Measure screws against scythe screws, cut with fine hacksaw and you can use and tighten up to make full contact,
You are left with 46 screws/washers/nuts for use for fans.
Only £2.99 in UK.LOL.
cheers