SimplyCool
|
||||
|
Ninja should fit on both boards.
Cheers, Stefan
__________________
![]()
|
|
|||
|
@lumdam
ich denke das wird gehen. wen du mein Board ansiehst ich habe noch Ramkühler etc. dran. Alles was An Kühler bei dir dran ist und unter 5 cm höhe ist sollte kein Problem darstellen. Es heisst probieren. Wen es nicht klaptt kannst ihn ja immer noch verkaufen auf Ebay. Hier noch die Massen des Ninja B Revision. Ich habe bereits den Ninja 2 drin und der wird nicht mal heiss. Ninja PLUS Dimensions and Compatibility |
|
|||
|
Ninja 2 fits on MSI P6N V2.
But I think its installation is only possible if the board is outside of the case... http://blog.increase.at/wp-content/g...2/sg103839.jpg http://blog.increase.at/wp-content/g...2/sg103836.jpg Last edited by hiroshige; 09-26-2008 at 10:23 AM. |
|
||||
|
Thx for the Picture!
__________________
![]()
|
|
||||
|
Danke für die Info!
__________________
![]()
|
|
|||
|
Hallo,
vielleicht ist es noch etwas früh, aber kann man schon eine vorsichtige Aussage machen, ob der Ninja Rev. B auf dem Gigabyte EP45-UD3P passt? Ich weiß, es sieht knapp aus. ![]() http://www.gigabyte.com.tw/FileList/...5-ud3p-4_b.jpg Vielen Dank. |
|
||||
|
Hihow,
Ninja passt sicher. Viele Grüße, Stefan
__________________
![]()
|
![]() |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
|
|






Linear Mode
