[dzidq]

Hello

Can anyone let me know if the Gigabyte ga-m57sli-s4 mainboard can take a Ninja Plus Rev. B?

My motherboard is like to ga-m59sli-s5 but i dont know it's true

This is my ga m570sli-s4



And 590sli-s5

So ask can i buy ninja plus rev.b for my ga-m57sli-s4 on my AMD 5000+ BE

P.S
Sorry for my language, my english is low lvl

[hiroshige]

Hello dzidq,

Ninja Plus should fit without any problems. If you are using RAM with high heatspreaders like Dominator, the Ninja could block one of your RAM slots.

Cheers,
Stefan

[Adam]

Hello is Ninja 2 (which is 6 mm wider and longer than Ninja 1) compatibile with this mainboard: DFI Lanparty DK P35-T2RS ?

PLEASE ANSWER QUICK!!!

[hiroshige]

Yes.

Fast enough?

[Adam]

YES! Thanks a lot, my friend!

[dzidq]

Thanks bro

[dzidq]

and one question more. I have little problem. I dont know what Cooler choice... ninje plus rev.b and ninja II
And qustion Ninja II is compatibility with my motherboard Gigabyte Ga-m57sli-s4

[hiroshige]

Hi dzidq,

I would suggest Ninja 2 - and yes, it should fit but when you are using RAM with high heatspreaders like Dominator, Ninja 2 blocks the first 2 slots.

Cheers,
Stefan

[dzidq]

Thanks for ur suggest So I'll buy Ninja II.
Thanks again

[Bulletman]

JUst installed that Ninja PLUS rev. B to my AN52S and it is working fine. Ate one of DIMMs, but got four so three left. Easy install Antec case had plenty of room to work. Did take graphic card off to gain more space. Three hundreds casefans were also in good places so my AMD dualcore prosessor has now quite windy place to be. First results show that temps through out the line have come down. Sys temp from 35-37C to 33C, CPU from 35-36C to 32-33C, even my Geforces temp got lower because it has passive cooling above the card and now Ninjas fan, which is under the heatsink, blows to cpu and from gpu. Now temp of gpu has declined from 51-55C to 45-46C. Those temps are when idle, but under some load, that CPUs temp didn't rise above 41C, when before it was sometimes even above 60C. And temp comes down quickly too. Before Ninja I had that standard heatsink/fan that comes in the boxed prosessor version. Sounds now better too, no whistling sound of that 7cm crappy fan, thank god! I think that my PC powersources 1-2C temp rise might come because after Ninja, wind draft could be more upwards and in this case PSU is located at the bottom, who knows?... It seems to be, that even HDDs temp has come down 1-2C... THANKS NINJA!!!

Wow, didn't mean to write that much... Enjoy!