Ninja CU & Ninja Mini Compatibility

[Oli]

I believe the Socket 478 bracket will begin some millimeters higher than the rails of the retention kit so as the rails clear the capacitors the bracket should clear them too.


Bye Oli

[newuser]

i am going to use Ninja MIni and not Ninja Copper for Asus P5k?

[Oli]

I've been testing Mugen and Ninja on P5K Deluxe and as all the P5K series boards are quite similar all the Ninjas (Rev B, Mini Ninja, Copper) should fit. No matter if using pushpins or retention kit.

[hiroshige]

Hi guys,

I'm really sure, that Ninja will fit - this is one of the coolers with the fewest compatibility issues.

Cheers,
Stefan

[newuser]

i guess that mean if i buy P5Q series board with Ninja Mini , it should also fit becauase P5Q deluxe is compatible also.

[hiroshige]

Yes, it should fit also.

[rom0n]

Would Scythe CU fit on Gigabyte P35 DS3R? It's not on the list. I'm afraid the North Bridge heatsink would block the Scythe Ninja CU.

[Oli]

In this thread you can see that Mugen should be compatible with DS3R, so Ninja CU shouldn't be a problem:
Best Scythe Cooler

I looked at a pic of DS3R - looks quite safe. I would have been much more concerned about Mugen as it's wider but as a staff member of Scythe believes that Mugen will fit on it I have little doubt concerning Ninja models.


Bye Oli

[hiroshige]

Oli is right - it should fit.

[s0ver]

Originally Posted by mike42

Is the Asus Rampage Formula compatible with the Ninja Cu?
Thanks

Originally Posted by Shinigami

mike42: Asus Rampage Formula should be basically compatible, but the mounting is going to be not really easy. You need to take time and connect the clips on the difficult side first, then the easier side. Then it should be fine.

Asus Rampage Formula is not compatible witch Ninja Cu

Has bought Ninja Cu two weeks ago and has received a problem with installation today having bought Asus Rampage Formula.
If you wish I could make and post photos of this problem.

I wish to know as to solve this problem...