SimplyCool
07-26-2010, 04:25 PM
|
||||
|
||||
Typical height of ATX I/O shield: approx. 1.47" (approx. 37,4 mm)
Typical height of standard DDR3 module: approx. 1.18" (approx. 30,0 mm) Distance underneath lowest fin of Mini Ninja (plus CPU socket height and CPU heatspreader thickness!): 35 mm If the chipset coolers are not higher than the top edge of the ATX i/o panel the Scythe cooler should have enough clearance. A high res side view of the board could help. Looking at photos of the M4A88TD-M EVO (http://thekyjsc.com/upload/thekyjsc_com_1276310442.jpg) I doubt that the coolers are really higher than the ATX panel. And Mini Ninja cleares the RAM modules. So good chances that it'll fit. Speculation / best guess.
__________________
- All comments relating to mainboard / cooler / case compatibility are based on "best guess". -
- Aussagen zur Kühler-Kompatibilität basieren auf unverbindlicher, persönlicher Einschätzung. - Push Postings will be deleted without notice. 
|
|
02-04-2011, 04:43 PM
|
|||
|
|||
|
Mugen 2 LGA1156 Conversion Kit made the Ninja Cu fit on Foxconn H67A-S LGA1155 mainboard.
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
