Official Scythe Forum - View Single Post

TEK · #72 (**permalink**) 11-05-2007, 12:32 PM

Thanks for your svift reply!

I agree, the cooler itself seems to fit.
You have quite a different revision than me (pre 1.0?), but mine has more room, not less than yours, so it looks fine.

The fan might cause an issue. My RAM module is elevated 36mm from the motherboard, 28mm from the CPU socket.
As far as I can tell the fan will be directly above my RAM units.

On the product photos the fan is lower down than the Ninja Mini cooler unit itself. Must the fan be monted that low? If so, what is the vertical distance between the bottom of the mounting plate and the bottom of the fan?
(I have the motherboard right here so I can mesure to check if it will fit)

Regards, TEK

#72 (permalink) 11-05-2007, 12:32 PM
TEK Junior Member Join Date: Nov 2007 Posts: 3	Thanks for your svift reply! I agree, the cooler itself seems to fit. You have quite a different revision than me (pre 1.0?), but mine has more room, not less than yours, so it looks fine. The fan might cause an issue. My RAM module is elevated 36mm from the motherboard, 28mm from the CPU socket. As far as I can tell the fan will be directly above my RAM units. On the product photos the fan is lower down than the Ninja Mini cooler unit itself. Must the fan be monted that low? If so, what is the vertical distance between the bottom of the mounting plate and the bottom of the fan? (I have the motherboard right here so I can mesure to check if it will fit) Regards, TEK