hi,
i checked now the behavior of the Server: If you set the treshold to 40° in Semi Mode: up to 40°c the Panel uses the min. rpm pre sets. If you reach 40°C there is a latancy of some seconds. in this time the panel check if this temp is stable/falls or go higher. after this it depends on how much the actual temp is above the treshold. The panel starts to spin up slowly. Excample: @ 41°C the panel gives ~ 70% and wait what happens. but not 100%. If the temperatur go up again the panel try to prevent this with full speed.
So its very imptortant to set the right temperatur for best controlling. So you maybe should check your maximum temp in MAN mode, than set the temps for AUTO/SEMI mode some degrees lower (1-2°C).
|