Official Scythe Forum - View Single Post

Oli · #4 (**permalink**) 08-22-2008, 07:18 AM

Yes.

There is one little difference that would matter if you have a difficult installation and wanted to use the Thermalright Bolt Thru Kit for Socket 775 - this is now slightly harder to install as Ninja 2 no longer offers the possibility to screw from the top with a long srew driver.

The design is now completely closed - no access to the screws possible. But this is only relevant for a very special setup.

#4 (permalink) 08-22-2008, 07:18 AM
Oli Senior Member Join Date: Aug 2007 Location: Germany, in the middle of Europe Posts: 443	Yes. There is one little difference that would matter if you have a difficult installation and wanted to use the Thermalright Bolt Thru Kit for Socket 775 - this is now slightly harder to install as Ninja 2 no longer offers the possibility to screw from the top with a long srew driver. The design is now completely closed - no access to the screws possible. But this is only relevant for a very special setup. __________________ C2D E6700@3.33Ghz@1,28V / Mugen, Ret Kit & 2x Slip Stream @ 550rpm / summer: idle 37 - load 70 / winter: idle 33 - load 64