I don't have a thermophobia, I just want to make sure, that my Ninja is installed correctly and the I get the maximum out of the cooler. Now if read correctly your statement, Ryan:
Quote:
Originally Posted by Ryan
I'd kill for these temps and that G0 chip. at 9x300 I have to use a vcore of 1.3750 just to get stable which is 1.3825 in my bios. And then I idle at 37-43.
|
With a Vcore of 1.3750 (9*300) you have temps in idle at 37-43 and exactly here is what I don't understand, as I have a Vcore 1.22 (9*333) and have idle temps of ~40°, i.e. much less Vcore, Q0 and still close to the same temps as you have.
And I also think, that if I want to OC 9*355/Vcore 1.29 with the Q0 the temps shouldn't be at 70° under prime load. So my guess is, that there must be something wrong with the cooler or with the thermal paste I applied or just the whole installation or I may have bought the wrong cooler...
My goal was and still is, to have a stable 9*355 with a quiet set-up, i.e. the fans shouldn't do more than 800 - 850 RPM.
Next step is, that I will take off the cooler and apply the thermal paste again, this time according to the instruction of Arctic. Let's see if this will work out better, if not I'll have to go for another cooler...