Hi there
I also have Ninja PLUS Rev B and I am wanting to use it for Socket 1156 motherboard
I see the mounting clip (
http://www.scythe-eu.com/en/products...ing-clips.html ) which Scythe has available does not support Ninja PLUS Rev. B model, because the dimensions seem to be different
As per this picture
http://www.scythe-eu.com/fileadmin/S...Rev_B-Base.jpg dimensions for Ninja PLUS Rev. B are around 38mm x 31mm for the heatsink
But the Ninja 2 dimensions, for which the bracket was made for are around 54mm x 54mm
http://www.scythe-eu.com/fileadmin/S...ja-2-unten.jpg
So mounting bracket will not fit
However, Ninja 3 dimensions are 38mm x 38mm which is very close to Ninja PLUS Rev B
http://scythe-eu.com/fileadmin/Suppo...mensions-2.jpg and Ninja 3 comes with this mounting kit
http://www.scythe-eu.com/uploads/tx_...cessory_01.jpg which looks like it could fit the screw holes for Ninja PLUS Rev. B
Also this mounting kit looks like it is very close to fitting Ninja PLUS Rev. B
http://www.scythe-eu.com/forum/attac...sparepart2.jpg
Are they compatible? Must only be a few mm difference...
I measured screw holes for Ninja PLUS Rev. B to be 18mm x 45mm apart
If it cannot fit, are you going to make a mounting kit that is similar to Ninja 3 or Mugen 2 that has two sets of screw holes that fit both Ninja 3 and Ninja PLUS Rev. B? It looks like it is very close in dimensions to fit
Thank you